Session2-Design of Boltes connections2-Autodesk Inventor
In this session, a step by step tutorial is introduced to apply the basic principles discussed in session1(https://www.youtube.com/watch?v=Y3X2B...). The session covers the followings:
-Placement methods of bolts.
-Type, size, standards of bolts, washers and nuts.
-Load and safety factors.
-Assigning material for bolt and joint.
-Mentoring results and preparing professional reports.
Kindly note the followings:
1-All concepts covered through this course are code-independent, however, the tutor has chosen Autodesk Inventor just for application.
2-Each topic in the course is treated as a building block.
3-The average duration for each session is about 20 minutes. They are kept short for audience’s convenience.
4-The expressions are kept simple and the emphasis is on practical tutorials to illustrate the topic. Please try to apply the tutorial by yourself after watching each session.
If you have any inquiries, please feel free to contact the tutor: amr.ahmed@eng.asu.edu.eg.
Note: All sessions' content is presented in Arabic.
-Placement methods of bolts.
-Type, size, standards of bolts, washers and nuts.
-Load and safety factors.
-Assigning material for bolt and joint.
-Mentoring results and preparing professional reports.
Kindly note the followings:
1-All concepts covered through this course are code-independent, however, the tutor has chosen Autodesk Inventor just for application.
2-Each topic in the course is treated as a building block.
3-The average duration for each session is about 20 minutes. They are kept short for audience’s convenience.
4-The expressions are kept simple and the emphasis is on practical tutorials to illustrate the topic. Please try to apply the tutorial by yourself after watching each session.
If you have any inquiries, please feel free to contact the tutor: amr.ahmed@eng.asu.edu.eg.
Note: All sessions' content is presented in Arabic.
تنبيه: جميع ما تقدمه هذه القناة من محتويات هي باللغة العربية
تعليقات
إرسال تعليق